Bissell pro heat 8920 manual

Table of Contents. ProHeat 2X. Previous Page. Next Page. Bissell user's guide vacuum cleaner series, series 25 pages. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your ProHeat 2X is well made, and we back it with a limited one-year warranty. See the cleaning fluid section of this guide Page 5 Optional Accessories: These items are available for purchase with your model.

To order replacement parts or additional tools or formulas, please refer to page Not only does it come with a lot of unique features, it has been designed with you, the customer, in mind.

Page 8 Until now, to maintain your Scotchgard 5-year limited stain warranty, you were required to hire a professional. Page 9: Before You Clean A. Allow to penetrate for at least 3 minutes C. Page 10 Set Custom Clean Dial. Carry the Tank like a bucket to a utility sink or outside where you will dispose of the collection water.

Unlatch the top of the Tank from the bottom by lifting the Tank Latch. Page 12 A few models are equipped with a Scotchgard Protector post-treatment applicator and cartridge. Then follow the related troubleshooting steps in the rest of this guide. Listen for unusual motor noise such as grinding, racing, louder than normal, etc.

If so, remove and replace the vacuum motor. Do not put the tank in the rear auto load receiver. The rear auto load receiver may remain empty as long as the unit is set to rinse. Putting the smaller formula tank in the front receiver leaves more room to see the receiver is making proper contact with the cap and insert. Turn the unit on and see if it sprays. If it does the tank is warped and needs to be replaced. Look for bubbles coming into the water tank. If bubbles are coming into the tank from the auto load receiver, the receiver may have a bad welded seam.

Replace the auto load receiver. The rinse setting is a positive off and will eliminate the formula tank from the spray system so that the pump will only draw from the water tank. If the unit will spray when set to rinse but not when set to normal there may be something wrong with the formula tank, auto load receiver, or seal. Remove the recovery tank top, place recovery tank bottom back on unit, turn unit back on, and check for spray. The recovery tank becomes negatively pressurized when the unit is running.

Removing the top eliminates that pressure and makes it easier for the pump to work. The pump is likely faulty if the unit will not spray with the top on but will spray after it is removed. Check operation of the solenoid valves. Pulling the trigger should energize the solenoid that is located in the base of the unit next to the heater volts should be sent to each solenoid valve after it is energized.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Page 9: Carpet Cleaning 3 minutes. Page 10 3. Page 11 perations Carpet cleaning continued 8. Remove the tank from the base of the machine by lifting up on the tank carry handle.

Page Cleaning With Attachments perations Cleaning with attachments Your PROheat 2X machine comes equipped with a hose and at least one attachment for cleaning stairs, upholstery, and more. Remove and rinse tools in clean, running water. Page Stain Removal 6. Wait minutes. Page Hard Floor Cleaning 2X hard floor solutions formula. Page Machine Storage perations Machine storage once your cleaning is complete, make sure the 2-in-1 water tank is emptied, rinsed out, and dried before the next use.

Note: Store cleaner in a protected, dry area. Page Maintenance And Care aintenance and care Machine care continued 5. Remove the cap by inserting a coin or a flat head screw driver into the slot on the top. Please do not return this product to the store.